SineWav Limiter

12345678

1. 1
   Ceiling lineDrag it. Nothing passes it, including the peaks between samples that ordinary limiters miss.
2. 2
   Soft zoneIn Soft mode the limiter starts easing in this far below the ceiling, for a gentler sound.
3. 3
   ReductionHow much the limiter is turning the signal down right now.
4. 4
   True peak and loudnessThe highest true peak sent out, plus short-term and momentary loudness in LUFS. Click it to reset.
5. 5
   Ceiling on the OUT meterThe ceiling rides on the OUT meter too. Drag it there, or double-click it to go back to -1.0 dBTP.
6. 6
   Transfer graphInput against output, with the ceiling and the soft zone drawn in.
7. 7
   Input gainTurn it up to make your voice louder. The limiter keeps the peaks under the ceiling.
8. 8
   Brickwall or SoftBrickwall does nothing until the ceiling, then stops dead. Soft eases in and still never goes over.

Windows · VST3 · one-time · 3 activations at a time. Every control is covered in the SineWav manual.